Step 1: Remove the door panel perimeter trim. Here's a view of the '67 door we'll be starting with. You can see the door panel has snap-on perimeter trim which must be removed to gain access to the door panel screws. If your door doesn't have this trim, you may skip to Step 2. Fig. 01. To remove these: Insert a wide flat head screwdriver behind the head of the plastic pin. This is to raise the head of the pin enough to slide a pair of flat pliers behind. Push the pin out 90% of the way (or all the way) and then the clip should release the side panel. Removing the Boot Liner (Side Panel Fixing)
golf 4 door panel removal
This boring D.I.Y is for other VW owners who, like me, are cheap and don't like car payments. Our car is an '03 GTI 1.8t with "only" 99k miles and is in grea

Replacing old damaged interior parts Volkswagen Golf MK4Here are the products used in the video:Soft rubber removal solution -

The front door lock modules are a bit over $100 each and the rears come in about $80 each. Not a horrible price if you want to avoid the hassle of opening the module to track down and fix the problem. Of course, those routes are cheaper. MKIV Door Lock Problems Summary. Door lock problems are far from uncommon on MK4 jetta, golf, and passat models.
How to remove the back tailgate panel trim VW Golf 6 GTI 2009 not 2015 :)6 Piece Torx set: Figure 8 Use a trim removal tool and pop the clip from the panel (red arrow). Figure 9 Using a trim removal tool (red arrow) start at the center of the panel and gently pull it away from the hatch. Figure 10 The lower section is attached to the upper section by a clip (red arrow) that sits inside the lower section (green arrow).
Picture 1) Use prying tool and pull towards you. Picture 2 & 3) Use a T30 Torx Screwdriver. Picture 4) Use 10mm Spanner and turn 90° degrees or use your finger. Picture 5 - 7) Use prying tool & YOUR HULK STRENGTH!! Picture 8) Door card half off with all the clips off. picture 9) PLEASE TAKE YOUR TIME DOING THIS PART.
1554 posts · Joined 2007. #4 · Apr 29, 2021. I found clean, leather door card panel inserts at the Pick-n-Pull and installed them into the door cards of my Jetta wagon. I attached the inserts using zipties and made a how-to video, showing the process: I just recently replaced the sagging fabric of the headliner in my wagon, also. K7J55xa.
  • f6fgmb0b7q.pages.dev/840
  • f6fgmb0b7q.pages.dev/348
  • f6fgmb0b7q.pages.dev/611
  • f6fgmb0b7q.pages.dev/952
  • f6fgmb0b7q.pages.dev/354
  • f6fgmb0b7q.pages.dev/984
  • f6fgmb0b7q.pages.dev/84
  • f6fgmb0b7q.pages.dev/363
  • f6fgmb0b7q.pages.dev/279
  • f6fgmb0b7q.pages.dev/655
  • f6fgmb0b7q.pages.dev/169
  • f6fgmb0b7q.pages.dev/928
  • f6fgmb0b7q.pages.dev/726
  • f6fgmb0b7q.pages.dev/591
  • f6fgmb0b7q.pages.dev/400

    • golf 4 door panel removal